Easy to Repair Broken Laptop Power Cord

Leave the power cord of your laptop without the power for the same months, and completely dead. No matter how you attack the strings in position or full battery power on your computer.

This is a solution to the amount of dollars and not only requires patience, some basic tools, electrical tape, and determined that only a real cheapskate could be found. I made this instruct able power to run my own HP Pavilion is a cable and adapter.

laptop power cord

-  Preparation and analysis

Tools to use: carving, sawing, electrical tape (or narrow tubes), cables and / or Strippers, flat head screwdriver (sharper and wide-ish), optional two monkeys for the wrench prying. Time: There is about 1 hour, almost all of which was spent trying to lift open the adapter.

-  Break Box: How to your adapter

There are many ways to learn how to open the adapter (ED494AA HP 65W AC adapter) box. Plastic is too weak to crack open w / only a screwdriver. This is just scratching the pressure, while the stage is firmly connected. So, I have managed to create a deep groove around the entire seam w / opaque. Groove helps.

-  HP AC adapter inside

It is important within the (HP Pavilion dv6000 AC adapter) in the upper and lower points of the sea. I was pretty much nothing more than to open it and try to prevent any damage to any part of the inside.

-  Adjust wire

Rope is rolled inside the box, barely. I removed all the sugar. Cut the last line of the second spring rubber (aka “strain relief”), which can break the line. Then I tried to decode reduce stress, w / fuse not work, so I use a razor and slit used for.

-  Close up, you can add reinforcements

Finally, I quit. Unfortunately, I use the adapter box has been locked exit doors, or close the connection or paste, so I wisely with a few black ducks and e-tape to finish. Some ideas were innovative and canned adapter w / glue guns.